Louvered Sliding Closet Doors – Louvered doors or shutters, the thin horizontal slats that provide air and sunlight to filter through. Such a door adds architectural detail to a room and a touch of old-world charm. Add the ventilated door panels on a flat surface with their upper and lower edges of the line. Install top hinges 7 inches from the top of the louvered door and put them in place with the screws provided with the Assembly. Repeat the process to install the middle hinge between the panels. In addition, ensure lower hinge in place, 11 inches from the bottom of louvered door panel.
Secure the pivot plates, the pins that fit into the groove and the floor bracket, the upper and lower edges of the side door jamb. Secure locking mechanism to the top of the door, which you install the knob, or the leading door. Plates, arms and installation hardware is available with bifold door assembly. Measure the width along the inside edge of the louvered sliding closet doors frame and cutting a length of the track to size using a hacksaw. Push the small stop in the center of the track. Place the ruts hangers around the stops and pivot base along the outer edge.
Put the track with hanging hardware on the door header and secure it in place using the screws provided with the unit. Place the track 1 inch from the edge of the louvered sliding closet doors header. Attach the louvered door floor bracket flush door frame with screws provided with the unit. Refer to the manufacturer’s measurements also provided for the exact location.